BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Security measures at work with a safety pillow
      Removal and steering wheel installation
      Removal and installation of the top facing of a steering column
      Removal and installation of a tip of steering draught
      Removal and installation of steering draught
      Hydropump fastening
      Removal of air and filling of hydrosystem of the amplifier of a wheel with a liquid
      Check and adjustment of corners of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics


Removal and installation of a tip of steering draught

 REMOVAL

1. Mark with a paint position of a wheel concerning a nave. Thanks to it отбалансированное the wheel can be established in former position. Ослабьте bolts of fastening of a wheel on the car standing on the earth. Lift and establish the car on supports and remove a wheel.
2. Turn away a counternut of fastening of a tip of steering draught, address to Section Removal and installation of a beam of a forward suspension bracket.

3. Turn away a nut of fastening of the spherical hinge at an inclined support.

4. Disassemble шаровый the hinge by means of a standard stripper, for example, HAZET 779-1.

5. Turn away a tip of steering draught. Thus keep steering draught a wrench from проворачивания.

At отворачивании count number of turns. It will facilitate adjustment later. Pay attention to presence of the right and left carving.


 INSTALLATION

1. Screw a tip on steering draught. The number of turns is equal earlier defined at a reversing.
2. Tighten a counternut of fastening of a tip the moment offered by Specifications.
3. Establish a tip in an inclined support. Fix its new self-stopped nut the moment offered by Specifications.
4. Establish and fix a forward wheel. Do not oil bolts or greasing. A wheel establish so that the marks put earlier at removal have coincided. Lower the car on wheels. Tighten cross-wise bolts of fastening of a wheel the moment of 100 Nanometers.
5. Adjust a convergence, address to Section Check and adjustment of corners of installation of wheels.