BMW 5 series E39

Since 1996-2001 of release

Repair and car operation

Body

Specifications

The sizes кузовных backlashes

Section	a =	b =	Section	With =	Sealant squeezing
A - A	4.5⁺¹_-0.5	21 2	A - A	-	-
B - B	10 1	12 2	B - B	-	-
C - C	-	10 1	C - C	12 2	2.5 1
D - D	-	12 1,5	D - D	12 2	1.5 1
E - E	12 2	10 1	E - E	-	-
F - F	21 2	4.5⁺¹_-0.5	F - F	-	-
G - G	13 2	13 2	G - G	5⁺¹_-0.5	-
H - H	22 2	22 2	H - H	5⁺¹_-0.5	-
I - I	4.5⁺¹_-0.5	-	I - I	-	-

Body of car BMW of 5th series the bearing. Dnishchevaja group, боковины, the roof and back wings are welded in a uniform design. Forward and back glasses are pasted. Repair of considerable damages, and also replacement of glasses should be made in conditions HUNDRED.

The cowl, cover of a luggage carrier, door and forward wings fasten болтовыми connections and can be without effort replaced.

Along with removal of elements of a body in the present Section removal of elements of the internal equipment, such, as seats and facings is described also. Many from specified above design elements have so-called screws Torx, for отворачивания which the special screw-driver is required.

Security measures at performance кузовных works

• At carrying out of welding or other works connected with искрообразованием, near to the storage battery, last should be necessarily disconnected.

• it is not necessary to spend welding or the soldering the soft or firm solders, the elements of a central air filled with a working body if there is a danger of heating.

It is not necessary to open a contour of circulation of a central air.

• body Elements, поверженные the strengthened corrosion, are zinced. Not сошлифовывайте a zinc covering before welding (it is authorised to remove a covering only at a ration firm solders). Thus the welding current should be increased by 10 %.

At welding of the zinced sheets zinc oxides are formed. Security measures demand good ventilation of area of carrying out of welding.

• the Sheeting of bottom PVC in a welding place is necessary for smoothing out a wire brush and, heating by hot air to temperature +180С, to remove шпателем. At heating of covering PVC from above 180С the hydrochloric acid rendering strong corrosive attack is formed. Besides, steams, unhealthy the person are formed.

• it is not necessary to heat up the car in the special furnace to temperature above +80С. Otherwise there is a danger of damage of electronic devices.