BMW 5 series E39

1. Remove a peak on the door end.

The peak consists of two parts. At first remove a screw-driver an average part, then external.

2. Through an assembly aperture enter tool BMW-513202 and lift a safety lath (1) lock plates (2) over a safety pad (3).

3. Enter tool BMW-513201 into an aperture of a lock plate (2) and press it at the lifted safety lath (1) forward.

4. Take out tool BMW-513202.

1. Remove door facing.

2. Make independently a hook of wire of 2 mm. The end unbend at right angle, х = 5 mm.

3. Insert a hook instead of the tool 513201 through an assembly aperture in a door end face into an ear of a lock plate.
4. Displace against the stop forward a lock plate with a hook.
5. Lift a lath (1) lock plates (2) screw-driver under a lock pad. In this position displace a lock plate with a hook (3) forward so that cuts in a lock plate have released the external handle of a door. On an accompanying illustration position of a lock plate is shown at the removed external handle. 3 - the hook has entered into an ear of a lock plate.

6. Take away the handle downwards and pull at an angle downwards.

1. Insert the external handle of a door into place and press it.

2. Pull a lock plate (2) tool BMW-513202 or a hook back so that it was fixed a safety plate.

3. Press the external handle and check up its work.
4. Establish into place facing if she acted in film.
5. Insert into place a peak at a door end face. Thus at first fix an external part, then press average.