BMW 5 series E39

Since 1996-2001 of release

Repair and car operation

Security measures at the reference with the device of a tension of a belt

   •  Replacement and check of devices of a tension of a belt of safety / of a pillow of safety should be made by specialised workshops. Carrying out of any constructive changes with the specified devices is not supposed.

   •  If as a result of failure of the car the device of a tension of a seat belt has worked, it it is necessary to replace on new (work HUNDRED).

   •  Before performance of any works with the device of a tension of a belt it is necessary to disconnect a cable of weight from the storage battery. For an exception of casual contact the cable tip is necessary for isolating.

   •  If not worked device of a tension has been removed from the car to store it it is necessary so that casual access to it has been excluded.

   • the  Device of a tension and the block of management of it are sensitive to blows. If they were dropped from height more by than 50 sm to apply them does not follow.

   •  By manufacture of welding works the clip of the welding device should be attached directly in a welding place. Just in case the block of management of the tension device should be disconnected.

   • the  Block of management of a pillow of safety/device of a tension is under the central console. For an exception of failures in its work do not place in близи it any magnets.

   •  it is not necessary to subject the device of a tension and the management block even to short-term influence of temperatures above +90С. The damaged elements are not subject to repair also them it is impossible to open. Before their installation again check up, whether the negative cable of the storage battery is disconnected and whether the plug is isolated.

   •  it is not supposed to remove and utilise the device of a tension of a seat belt independently At all. Danger of explosion!

System check