BMW 5 series E39

1. Wring out above both facings of the S-rack and disconnect them from two clips.
2. Расстыкуйте штекерное connection of internal illumination also put aside a cover with a lamp.
3. Disconnect below a seat belt.
4. Remove a seat back. At a back with the device of pass for cargo cast away a back forward.

5. From a luggage carrier turn away three nuts of fastening of jalousie of back glass. Preliminary mark position of nuts. For this purpose lead round a felt-tip pen a washer.

6. Расстыкуйте штекерное connection of a drive of jalousie on the right in salon.
7. Remove external headrests. For this purpose extend them completely upward, press slightly forward and back and take out upward.

1. Disconnect a peak of headrests. For this purpose lift a peak, pull it at an angle back and upwards and take out forward.
2. Расфиксируйте a headrest also put forward it upwards. For this purpose a finger through an aperture in a hanger under a headdress press the lever of an unblocking and shift it forward, overcoming force a spring. The blocking lever is on an inside of an external directing core.
3. Disconnect a reception part of an average headrest.
4. Take out peaks of belts from a hanger for a headdress and disconnect together with belts.
5. Disconnect four clips of fastening of a hanger, having turned away the plastic screw with crosswise шлицем.

In the presence of the device for cargo pass it is necessary to disconnect six clips.

6. Pull a hanger a little forward. Thus ask the assistant to press through apertures screws of fastening of jalousie of back glass in a luggage carrier. From salon pull upwards jalousie for lateral apertures, simultaneously having pulled a cover forward. Thus, fingers of fastening of jalousie over the resonator of loudspeakers rise.

1. Insert a hanger and shift it back. Thus four support of a hanger should enter into directing bodies.
2. Fix a shelf from a luggage carrier three nuts and washers according to marks (6 Nanometers).
3. Insert four or accordingly six clips. Screw plastic screws.
4. Insert into a hanger for a headdress belts with peaks. Peaks fix.
5. Fix on a seat back a reception part of the central headrest.
6. Establish a peak of headrests if he acted in film.
7. Insert external headrests and fix them.
8. Join штекерное connection of jalousie of a back seat or cast away it.

9. Fix belts (4) below a bolt (1) and a washer (2), tighten the moment of 50 Nanometers. Address to an accompanying illustration.

At installation the pad (3) should lie above.

10. Join штекерное connection of illumination of salon and fix S-rack facing.