BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


Removal, installation and check of a sound signal

Behind a forward bumper are on the right side established on one sound signal of high and low tone. For protection of a sound signal between the button of a signal and a signal the relay is established. By pressing of the button of a signal the relay chain becomes isolated.

 REMOVAL

1. Lift a forward part of the car and establish on supports.
2. Remove the bottom guard of an impellent compartment, address to Section Removal and installation of the bottom guard of an impellent compartment.

3. Turn away bolts of fastening (2) sound signals with holders. Расстыкуйте штекерное connection also take out signals.


 CHECK

1. Attach a sound signal auxiliary wires directly to the storage battery.
Thus the violet-dark blue cable incorporates to a positive pole (+), and a brown cable with a negative pole of the battery. After connection the sound signal should work.

It is possible to reach a sound signal also if to take out the right air lattice from a bumper. For this purpose it is necessary to pull a lattice forward at the right lath.


 INSTALLATION

1. Insert a sound signal and fix its bolts.
2. Join штекерное connection.
3. Establish the bottom guard of an impellent compartment.