BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


Safety locks

Protection of electric contours of the car is provided with application of a combination of safety locks, breakers of a chain and fusible inserts. The burnt down safety lock is easy for distinguishing from serviceable by survey of its transparent plastic case. Attentively examine a safety lock about its revealing перегорания. If the safety lock outwardly looks normally, but suspicions on its malfunction have remained, make conductivity check between ножевыми the plugs acting from its case.

Перегорание safety locks of this kind can be revealed by visual survey

At replacement of safety locks watch conformity replaceable old on type. The safety locks calculated on a various current strength can outwardly look identical, therefore it is necessary to give special attention to marks. Replacement of the burnt down safety lock on calculated on smaller – and especially big – a current strength is undesirable. Each electric contour requires different degree of protection. Watch that marks on the safety lock case corresponded to a current strength on which the corresponding contour is calculated.

If the replaced safety lock immediately fuses, it is not reasonable to continue its replacement. Before it is necessary to reveal and eliminate its reason выбивания. In most cases that appears short circuit of electroconducting of the contour, caused by breakage or damage of isolation of a wire.