BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


course c++

Removal and installation of the electric motor of adjustment of range of light

 PERFORMANCE ORDER

1. Remove a headlight, address to Section Removal and headlight installation.

2. Remove рассеиватель. For this purpose wring out five plastic скоб (arrows on an accompanying illustration) a little.

3. Wring out a screw-driver скобу between a signal of turn and a headlight a little, () the kind see an accompanying illustration.

4. Remove linings of reflectors of headlights.

5. Wring out the block of a headlight from three spherical heads (two headlights for manual adjustment (1) and one for adjustment of range (2) and take out the block.
6. Расстыкуйте штекерное connection.
7. Turn away screws of fastening (3) electric motors of adjustment and take out it.


 INSTALLATION

1. Insert the electric motor of adjustment of range and fix its screws.
2. Join штекерное connection.
3. Establish the headlight block on three spherical heads.
4. Put linings.
5. Insert a headlight in рассеиватель and fix it.
6. Adjust a headlight, address to Section Adjustment of headlights.