BMW 5 series E39

Since 1996-2001 of release

Repair and car operation


BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   - Back suspension bracket
      The air shock-absorber of a back suspension bracket
      Removal and installation of the back shock-absorber
      Dismantling of an amortisation rack
   + Steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Dismantling of an amortisation rack

Installation of the shock-absorber and spring of a back suspension bracket is made similarly to installation of the shock-absorber and a spring of a forward suspension bracket, address to Section Dismantling of an amortisation rack/shock-absorber. Removal and installation of a screw spring.

 PERFORMANCE ORDER

1. At assemblage of a back amortisation rack it is necessary to pay attention to that the carving finger (1) support lay flush with an aperture of a rubber support (2) and on the contrary plugs.

2. Tighten a nut of fastening of a support on a rod of the shock-absorber the moment of 25 Nanometers