BMW 5 series E39

Since 1996-2001 of release

Repair and car operation


BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   + The power supply system
   + System of injection of the petrol engine
   + The power supply system of the diesel engine
   - System of release of the fulfilled gases
      Work каталитического the converter
      Security measures for cars with каталитическим the converter
      Removal and installation of system of release
      Replacement of the basic muffler
      Removal and installation of the gauge of oxygen
      Check of tightness of system of release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Removal and installation of the gauge of oxygen

At drawing of an anticorrosive sheeting of the bottom it is necessary to close the oxygen gauge.

REMOVAL

1. Uncover over injectors, address to Section Removal and installation of the inlet pipeline.

2. Lift and establish the car on supports.

3. Расстыкуйте штекерные connections of gauges of oxygen. Address to an accompanying illustration.

4. Open a cable collar.

5. Turn out gauges of oxygen from a final collector. For an exception of damage of wires wind them.

INSTALLATION

Do not clear oxygen gauges, in particular, an emery paper.

1. Spray a carving of the gauge high-temperature special greasing “Antiseize”.

If the gauge is rolled without a covering by high-temperature greasing, in due course to turn away a carving begins impossible.

2. Screw the oxygen gauge in a final collector and tighten the moment of 30 Nanometers.
3. Join штекерное gauge connection. The cable should be laid so that it did not fray at contact to the muffler.
4. Establish an engine cover.