BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Manual transmission
Removal and installation РКПП and АТ
Removal and installation of the lever of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics
|
Removal and installation of the lever of a gear change
|
1 — the gear change lever
2 — the lever
3 — the bearing
4 — a switching bar
5 — a remote washer
6 — a lock washer
7 — the switching hinge
8 — a lock ring
9 — a rubber washer
10 — a pin
11 — a protective casing
12 — a finger
13 — the plug
14 — a support
15 — the switch of lanterns of a backing
16 — гаситель fluctuations
17 — a label |
|
1. Strongly pull a lever head upwards. |
|
2. Disconnect a protective casing of the lever from the central console and remove it from the lever. |
|
3. Lift and establish the car on supports. From below remove lock скобу (4) and remove a switching bar. Remove from both parties of a washer (5). |
|
4. Put from below at the switching lever цапфовый a wrench (for example, special tool BMW 251110) and turn it on a corner 90 counter-clockwise. Remove upward a hinge casing. |
5. Disconnect a protective casing from a body and the console of switching and take out together with the lever upward. Disconnect a collar гасителя fluctuations if it is available, at the lever of switching and remove it. |
|
|
|
| 1. Grease spherical loose leaves of the lever of switching with plastic greasing “Kluber Polylub GLY 801”. |
2. Establish the lever of switching with the spherical loose leaf so that the pad or an arrow on the loose leaf showed in a finger direction, i.e. In a movement direction. |
|
3. Press the loose leaf a screw-driver from above in the holder so that pads were distinctly latched.
4. Insert a finger of draught of switching with washers into the lever. Establish a stopper. Lower the car on wheels.
5. Fix a protective casing. Thus an internal edge insert over the switching lever, and external into body cut.
6. Establish гаситель fluctuations and fix a collar. Fix a cover with a protective casing.
7. Establish a head on the lever and strongly press it. |
|
|
|