BMW 5 series E39

Since 1996-2001 of release

Repair and car operation

BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
- Systems of cooling, heating
   + Cooling system
   - Heater
      Removal and installation of the block of management by a heater or the conditioner
      Removal and installation of the gauge of temperature of the block of management by a heater
   + Air conditioner
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Heater

The general data

1 — the heater fan
2 — a bolt
3 — a final step of the fan
4 — the gauge of temperature of air in salon
5 — the gauge of temperature of the heating device
6 — a vacuum hose, black
7 — consolidation of joining of external air
8 — a ventilating branch pipe
9 — a drive cable заслонки
10 — a cable
11 — a fan cover
12 — дефлектор the heating channel
13 — a clip
14 — a bolt
15 — the heating fan
16 — a cover of heating elements

17 — дефлектор the heating channel
18 — a drive cable:
Area of feet:
  And - green,
   With - green
Defrosting:
   And - red,
   With - red
Ventilation:
   And - dark blue,
   With - dark blue
19 — a position drive заслонки
20 — the printed-circuit board
21 — a peak
22 — the handle of distribution of a stream
23 — the handle of installation of temperature

External air for heating is sucked in through soaking up lattice of the case of the air filter which is under a windscreen, and the fan moves in car salon. Thus air passes through a heater box, and therefrom through separate nozzles arrives in salon.

Management of air stream is carried out заслонками, cables set in motion. If the heater is established in a mode “warm” ("warmly"), air stream goes through a radiator. The radiator is in a box of a heater and is warmed with a hot cooling liquid.

The passing stream of air heats up as a result of contact with plates of a radiator and arrives in salon. Thermal productivity is regulated by a stream of a cooling liquid for what the system has two electromagnetic valves in a contour of system of cooling.

Regulation of temperature of air is carried out by the rotary handle, separately for the right and left half of salon. The electronic device in the management block operates time of opening of cranes of a heater depending on temperature in salon. The temperature gauge is located behind a heater box. Thanks to electronic regulation air temperature is supported close to a constant, irrespective of speed of the car and external temperature.

For strengthening of a thermal stream the heating fan having smooth regulation serves.