BMW 5 series E39

1. Mark with a paint position of a wheel concerning a nave. Thanks to it отбалансированное the wheel can be established in former position. Ослабьте bolts of fastening of a wheel on the car standing on the earth. Lift and establish the car on supports and remove a wheel.

2. Turn away a nut of fastening of the spherical hinge at an inclined support.

3. Disassemble шаровый the hinge a stripper, for example, HAZET 779-1.

4. Remove a collar and shift a protective cover back.
5. Move gear рейку as far as possible.
6. Disconnect steering draught (marksman).

1. Measure length of old steering draught. At new steering draught a tip screw so that to receive earlier existing size. Законтрите a tip.
2. A counternut tighten the moment of 45 Nanometers.
3. If it is necessary, clear a finger of the spherical hinge and a place of its landing in a rotary support of greasing.
4. Check up a protective cover and if necessary replace.
5. Fix steering draught on gear рейке the moment presented in Specifications.
6. Put on a protective cover and fix its new collar. Watch that the cover was not overwound.
7. Insert a tip of steering draught into a rotary support. Screw a new self-stopped nut and tighten its moment specified in Specifications.
8. Establish and fix a forward wheel. Bolts of fastening of a wheel do not grease. A wheel establish so that the marks put at removal have coincided. Lower the car on wheels. Tighten bolts of fastening of a wheel the moment of 100 Nanometers.
9. Adjust a track, address to Section Check and adjustment of corners of installation of wheels.