BMW 5 series E39

Since 1996-2001 of release

Repair and car operation

+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   + The power supply system
   - System of injection of the petrol engine
      Memory of malfunctions
      Security measures and rules of observance of cleanliness at work with injection system
      Work of system of injection
      Check of systems of ignition and injection
      Adjustment of a drive of gas
      Removal and installation of a branch pipe throttle заслонки
      Removal, check and installation of the valve of adjustment of idling
      Check, removal and installation of the gauge of temperature
      Check of injectors
      Removal and installation of injectors
   + The power supply system of the diesel engine
   + System of release of the fulfilled gases
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Adjustment of a drive of gas

The gas drive is very sensitive to breaks and consequently, at its installation, it is necessary to be careful. The small break can lead later to breakage in the course of movement. A cable having damages, it is not necessary to establish.
At cars with automatic adjustment of speed (темпостатом) at the lever throttle заслонки the additional drive of gas is fixed. If it is necessary, the specified cable is disconnected similarly to the basic.



1. Completely press a pedal of gas and press it in this position. For this purpose establish wooden брусок between a seat and a pedal.

2. Press the lever throttle заслонки, having established it in position of full gas and turn an adjusting nut (1) so that a cable has stretched, address to an illustration. Release a gas pedal.

Detachment of a drive of gas from the lever throttle заслонки


1. Give gas the lever throttle заслонки to unload nipples of a cable of gas. Address to an accompanying illustration.
2. Take out a nipple (2) of a segment.
3. Take out a cover of a cable from a support (1).

Cable connection


1. Pass a cable through the rubber plug of a support.
2. Give gas the lever throttle заслонки, connect a cable nipple. Check up adjustment of a drive of gas.