BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
- The power supply system and release
+ The power supply system
+ System of injection of the petrol engine
- The power supply system of the diesel engine
Турбокомпрессор
System рециркуляции the fulfilled gases (system EGR)
The device of heating of the fuel filter
Removal of air from fuel system
Check, removal and installation fuel запорного the valve
Removal and installation of atomizers
Check and adjustment of the moment of the beginning of injection
Removal and installation of the inlet pipeline
+ System of release of the fulfilled gases
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics
|
Removal and installation of the inlet pipeline
The inlet pipeline should act in film for providing of access before work, for example, on fuel system.
|
| 1. Remove covers of the engine and a pressurisation pipe. |
| 2. Disconnect a cable of weight from the storage battery. The battery is in a luggage carrier behind the right lateral facing. |
|
|
| 3. Remove from the inlet pipeline a cover of positive contact. Disconnect a positive cable of the storage battery and compress two clips. Remove a socle downwards. |
4. Remove the inlet pipeline from a head of cylinders. For this purpose disconnect a cable of the gauge of temperature of air of pressurisation (3). Address to an accompanying illustration. Disconnect a vacuum hose at the valve рециркуляции the fulfilled gases (5) and at the bottom part of the inlet pipeline. Turn away bolts of fastening and remove the inlet pipeline with a sealing lining (1) from a head of cylinders and from the holder. The valve рециркуляции the fulfilled gases with a lining (4) do not remove. |
|
|
|
1. Fix the inlet pipeline on a head of cylinders the moment of 25 Nanometers. All linings put the new. A support of the case of the oil filter and the pipeline рециркуляции fix to the inlet pipeline also the moment of 25 Nanometers.
2. Fix a socle of a positive pole on the inlet pipeline and screw шестигранник. Put on a cover.
3. Establish covers of the engine and a pressurisation pipe, address to Razdelu Turbokompressor.
4. Attach a negative cable of the storage battery. Establish hours. Program radio receiver stations. |
|
|
|