BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Antiblocking system
   Removal and installation of lobbies brake колодок
   Removal and installation of a brake disk / of a support of a forward brake
   Removal and installation back brake колодок
   Removal and installation of back brake supports
   Removal and installation of a brake disk of back wheels
   Measurement of a thickness of a brake disk
   Brake liquid
   Removal of air from brake system
   Replacement of brake pipelines
   Replacement of a forward brake hose
   Check of the vacuum amplifier of a brake
   Removal and installation brake колодок a lay brake
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of a cable of a lay brake
   Check and replacement of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics


Check and replacement of the switch of a stoplight

The stoplight switch is in area of feet at a support of a pedal of a brake.

 CHECK

1. If the stoplight does not light up, check up first of all a safety lock. Then check up lamps накаливания. If lamps are serviceable, check up the stoplight switch.
2. Uncover around feet (over a pedal).
3. Расстыкуйте штекерное connection of the switch of a stoplight, having compressed lock pads.
4. Include ignition.
5. Connect both contacts in the tip of the switch of a stoplight a short auxiliary wire. If thus the stoplight does not light up, replace the stoplight switch.


 REMOVAL

1. Remove the bottom cover in the left part of area of an arrangement of feet.

2. Расстыкуйте штекерное switch connection, having compressed lock pads. Address to an accompanying illustration.
3. Press a brake pedal. Pull forward (3) pusher (1) and the plug (2). Address to an accompanying illustration.
4. In this position compress a clip (4) and extend the switch back from the holder.


 INSTALLATION

1. Insert the switch with completely extended plug into a support of a pedal and fix.
2. Insert the red safety plug into the switch so that the plug fillet adjoined to a pedal support.
3. Join штекерное connection and fix it.
4. Check up, whether the stoplight lights up at the included ignition.
5. Establish the bottom cover.