BMW 5 series E39

Since 1996-2001 of release

Repair and car operation


BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Antiblocking system
   Removal and installation of lobbies brake колодок
   Removal and installation of a brake disk / of a support of a forward brake
   Removal and installation back brake колодок
   Removal and installation of back brake supports
   Removal and installation of a brake disk of back wheels
   Measurement of a thickness of a brake disk
   Brake liquid
   Removal of air from brake system
   Replacement of brake pipelines
   Replacement of a forward brake hose
   Check of the vacuum amplifier of a brake
   Removal and installation brake колодок a lay brake
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of a cable of a lay brake
   Check and replacement of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Removal and installation of the lever of a lay brake

 REMOVAL

1. Remove the central console, address to Section Removal and installation of the central console.

2. Completely turn away a counternut and adjusting nuts of cables of a drive of a brake.

3. Disconnect an electric wire (1).
4. Turn away bolts of fastening and remove the lever of a brake (arrow).

 INSTALLATION

1. Enter cables of a drive of a lay brake into the lever. Insert and fix the brake lever.
2. Tighten by hand nuts of cables.
3. Adjust a lay brake, address to Section Adjustment of a lay brake.
4. Include ignition. At the switched off lay brake the control lamp should go out. If it does not die away, adjust the brake switch.
5 Establish the central console.