BMW 5 series E39

Since 1996-2001 of release

Repair and car operation


BMW E39
+ Introduction
- The maintenance instruction
   Controls, devices and control lamps
   Zapornye devices and the anticreeping alarm system
   The salon equipment
   Safety systems
   Fuel refuelling, start and engine stop
   Lay brake
   Manual box of a gear change (РКПП)
   Automatic transmission (АТ) *
   Темпостат
   The alarm system of emergency rapprochement at a parking (PDC) *
   System of automatic stabilisation of stability with a regulator of traction effort (ASC+T)
   Electronic adjustment of rigidity of amortisation (EDC) * and adjustment of a road gleam
   Illumination
   Heating and ventilation system
   Automatic кондиционер*
   Independent systems of heating and ventilation
   System самодиагностики*
   The travelling computer
   Обкатка
   The Katalitichesky converter
   Antiblocking system of brakes (ABS)
   Movement with the trailer
   Luggage carrier on a roof
   Automobile телефон*
   Radio reception
   Readjustment of headlights
   Cowl
   Automobile radio receiver
   Audiosystem of type Hi-Fi with DSP*
   Sign emergency остановки*
   Аптечка*
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Темпостат

The system allows to remember and automatically to support demanded speed at level not below 30 km/h.

The system can be included already after ignition key turn in position by 1 pressing of the key shown by an arrow. Thus on an instrument guard the control lamp lights up.

By repeated pressing of a key the system is switched off.

1. The button of movement with the set speed, storing and dispersal
Press the button.
Actual speed which is supported by a constant is entered into memory of system. Each subsequent pressing of the button speed will increase by 1 km/h.
If to keep the button in the pressed position the car will be dispersed without influence on an accelerator pedal. If to release the button, the speed reached to this moment remains in memory of system and will be supported by a constant.

2. The delay button
Press the button.
If before movement already occurred in a mode of maintenance of the set speed by each pressing of the button speed will decrease for 1 km/h.
If to keep the button in the pressed position at movement in a mode of maintenance of the set speed degree of opening throttle заслонки automatically will decrease also the car it will be slowed down. If to release the button the speed reached to this moment remains in memory of system and it will be supported constantly.

3. The call button
Press the button.
There will be a call of last of the entered values of speed to which it at first will be finished, and then begins to be supported by a constant.

4. The button of deenergizing of automatics
Press the button.
Automatics of maintenance of the set speed will be switched off at once.

Besides, the system is automatically disconnected in following cases:
- At braking, deenergizing of coupling or while translating control lever АТ from position D in position N.
- For BMW 520i, 523i, 528i, 535i, 540i: if the set speed is exceeded throughout more 30 with and more than on 16 km/h.
- For BMW 525tds: if the set speed is exceeded more than on 16 km/h or decreases more than for 20 km/h.

With ignition key turn in position 0 system will be switched off, and the entered value of speed will be erased.

To use automatics of maintenance of the set speed it is impossible, if the line abounds with turns or if the raised intensity of movement does not allow to move in regular intervals, and also on slippery (because of snow, a rain, ice) road or weak (gravel, sand) a ground. Otherwise your style of driving will not correspond to a road and transport situation.