BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


Check of gauges

Gauges concern, in particular: the gauge of the relay of pressure of oil, the gauge of a reserve of a brake and cooling liquid.

 CHECK

1. Attach a control lamp or an ohmmeter to switch plugs. For this purpose disconnect cables from the switch.

The switches screwed in the block of cylinders, as a rule, have no weight cable as connection with weight is carried out through the case.

2. At the closed switch the device should give evidences. Is better to use for this purpose an ohmmeter. At the closed switch the ohmmeter should show a zero the Ohm at opened infinity the Ohm.
3. Working capacity of gauges of a reserve of a cooling liquid and a brake liquid is the most easier for checking up as follows. At the included ignition disconnect from the switch a wire and put it to a reliable point of weight, for example to the block of cylinders. If the corresponding signalling device on the panel of devices, malfunction in the switch lights up.
4. The special case represents the gauge of the relay of pressure of oil. At the idle engine contact is closed (a signalling device burns). The switch works only at certain pressure of oil.