|
Check of a heater of back glass
After inclusion of heating of back glass its field having threads of heating, should be cleared of ice after a while.
|
| 1. In the presence of malfunctions at first check up a safety lock in the block of safety locks.
2. If the safety lock is perfectly in order, check up reliability of connection of the tip at the left and on the right back glass. If necessary smooth out from corrosion. |
| 3. If after that heating of back glass still does not work, check up wires and the switch, and also a chain. |
4. If heating threads have breakage, to liquidate it it is possible by means of a usual zilber-varnish. For this purpose clear the damaged place a thinner or этиленом. Address to an accompanying illustration.
5. From two parties of the torn off thread paste a sticky tape and a small brush put a zilber-varnish.
6. Allow to dry up to a covering at temperature +25С within 24 hours. The hair dryer can be applied to this purpose. At temperature +150С the covering dries up within 30 minutes |
|
| |
Do not include heating of back glass, the covering has not dried up yet. Do not apply to clearing of the damaged place gasoline or other solvents. |
|