BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


Removal and radio receiver installation

REMOVAL

1. Remove the button of a regulator of loudness.

2. Insert a screw-driver into a cut near to an axis of a regulator of loudness and turn on 90 . Take out to the left a screw-driver and together with it the control panel and take away them to the right.

If the screw-driver directly does not enter into a groove, put it, turn on 90 and, thus, having displaced a clamp to the right, simultaneously open a groove. Turn a screw-driver further and insert into a groove.

3. Расстыкуйте штекерное connection. For this purpose reject aside a clip.

4. Turn to the left two screws of fastening (3) radio receivers with internal шестигранником so that it could be taken out easily.

5. Расстыкуйте multipolar штекерное connection (1) screw-driver. Disconnect a cable of weight (2). Disconnect an antenna wire (3).


 INSTALLATION

1. Join multipolar штекерное connection and an antenna wire with a radio receiver underside. Fix the screw a weight cable.
2. Insert a radio receiver into an aperture of the panel of devices.
3. Fix screws with internal шестигранником.
4. Establish multipolar штекерное connection at the radio receiver control panel. Cast away a clip and fix it.
5. Insert the control panel into an aperture of the panel of devices of the car so that it was fixed.
6. Establish the button of a regulator of loudness.