BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Diagnostics of malfunctions of an onboard electric equipment - the general information
Safety locks
Fusible inserts
Chain breakers (thermal relays)
The relay
Relay check
Check of lamps накаливания
Check of electric motors
Check of electric switches
Check of switches of lamps and electric motors
Check of gauges
Check of the electric motor of a screen wiper
Stoplight check
Check of a heater of back glass
Removal and switch installation
Removal and installation of the gauge of temperature
Removal, installation and check of a sound signal
Remote control initialization by the uniform lock
Adjustment of range of light of headlights
Removal and installation of the electric motor of adjustment of range of light
Replacement of safety locks
Arrangement of safety locks
Illumination devices
Replacement of lamps накаливания
Removal and headlight installation
Adjustment of headlights
Removal and installation of a back lantern
Monitors
Removal and installation of the block of the panel of devices
Replacement of lamps of the block of the panel of devices
Removal and installation of the switch of signals of turn/screen wiper
Removal and radio receiver installation
Screen wiper
Replacement of brushes of a screen wiper
Removal, installation and adjustment snuffled стеклоомывателя
Removal and installation of a drive of a screen wiper/cover
Removal and installation of the electric motor of a screen wiper
Check and pump replacement стеклоомывателя
Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics
|
Replacement of lamps накаливания
It is recommended to have with itself in the car spare lamps. On sale the box with the complete set of spare lamps is offered. The list of lamps is resulted in Specifications.
Switch off the switch of a corresponding lamp.
Headlights
| |
Galogennye lamps distant, a passing light and antifog light are under pressure. For protection of eyes use points, for protection of hands - gloves. Otherwise at lamp damage there is a danger травмирования. |
|
1. Open a cowl. |
|
2. Turn to the left against the stop the holder of a lamp of a passing light (1) and take out it. |
|
3. Take out a lamp and replace it.
4. Establish the holder of a lamp of a passing light and turn it to the right against the stop.
5. Turn to the left against the stop the holder of a lamp of a headlight (2) and take out it
6. Расстыкуйте штекерное connection.
7. Establish the new holder of a lamp with a lamp on a connector and fix it.
8. Establish the holder of a lamp of a headlight and turn to the right against the stop. |
|
Parking light
|
1. Turn to the left against the stop the holder of a lamp of a parking light (3) and take out it. |
|
2. Take out a lamp and replace it. |
3. Insert into the case the holder of a lamp the big pad upward and turn to the right. |
|
|
Signal of turn the forward
|
1. Compress the holder of a lamp for pads and take out it back.
2. Slightly press a lamp in the holder, turn on the left and take out.
3. Insert a new lamp, press it in the holder, turn to the right and fix.
4. Press the holder of a lamp and fix it. |
|
The lateral repeater of turn
|
1. Press a lamp fingers at a back edge forward and take out.
2. Turn a lamp on the left, slightly having pressed and take out.
3. Slightly press on a new lamp, turn to the right and fix it. |
|
Antifog headlight
| |
Galogennye lamps distant, a passing light and antifog light are under pressure. For protection of eyes use points, for protection of hands by gloves. Otherwise at lamp damage there is a danger травмирования. |
|
1. Remove a clip of a decorative lattice. For this purpose take out a pin (2), then a clip (1). |
|
2. Disconnect a decorative lattice above and take out it.
3. Take out forward a cover near to an antifog headlight. |
3. Turn out 2 two bolts of fastening and take aside an antifog headlight. |
|
4. Press a spring (1) from an underside in an arrow direction on an accompanying illustration. |
|
5. Hook a cover (2) on the one hand and disconnect it with another. |
6. Disconnect a spring clip (1) of the holder (2). |
|
7. Remove covers of contacts and replace a lamp.
8. Fix a new lamp a clip.
9. Check up a condition of a lining (3) in a cover, if necessary replace.
10. Insert a cover, press it and fix a spring clip.
11. Insert an antifog headlight and fix its screws.
12. Fix a decorative lattice, press a clip and fix it разжимными pins. |
|
Back lantern
|
| 1. Open a luggage carrier cover.
2. Remove lateral facing. |
3. Turn to the left on 90 a clip (1) and remove the holder of a lamp (2). |
|
4. Slightly press a lamp in the holder, turn to the left and take out. |
5. Insert a new lamp, press it a little in the holder, turn to the left and fix. |
|
6. Establish the holder of a lamp and turn a clip. |
|
It is central the located stoplight
|
1. Open a luggage carrier cover.
2. Remove a screw-driver a black plastic cover from the bottom party of a hanger under headdresses.
3. Turn to the left the holder of a lamp and take out it.
4. Insert a new lamp, having pressed it a little in the holder, turn to the right and fix.
5. Establish the holder of a lamp and fix, having turned to the right.
6. Fix a plastic cover from the bottom party of a shelf under headdresses. |
|
Lantern of illumination of licence plate
Capacity of a lamp of 5 Vt
|
1. Insert a screw-driver into a cut and press to the right, as shown an arrow; the lantern leaves fastening. |
|
2. Remove a lantern and replace a lamp |
|
Plafonds
Forward plafond
The basic lamp (10 Vt), lamps of individual illumination (10 Vt)
|
1. The basic lamp. Squeeze out a plafond, having hooked it sideways a screw-driver, and remove glass then take a lamp from contact holders.
2. A lamp of individual illumination. Take out a lamp, slightly having pressed on it and having turned to the left |
|
Back plafond
The basic lamp (10 Vt), lamp of individual illumination (5 Vt)
|
1. Squeeze out a plafond, having hooked its screw-driver, having inserted into dredging from above
2. The basic lamp. Having wrung out a uvula on a reflector, replace a lamp
3. A lamp of individual illumination. Take out a lamp, slightly having pressed on it and having turned to the left |
|
Lamps of illumination of a niche for feet
Capacity of lamps of 5 Vt
|
1. Remove lamp glass, having hooked it sideways a screw-driver
2. Replace a lamp |
|
Lantern of illumination of a ware box
Capacity of a lamp of 5 Vt
|
1. Squeeze out a lantern, having hooked its screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp |
|
Lanterns of illumination of a luggage carrier
Lamp under a shelf behind back seats: 10 Vt, галогенная
Lamp in a luggage carrier cover: 10 Vt
|
1. Squeeze out a lantern, having hooked its screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp |
|
|
|