BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   The relay
   Relay check
   Check of lamps накаливания
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of gauges
   Check of the electric motor of a screen wiper
   Stoplight check
   Check of a heater of back glass
   Removal and switch installation
   Removal and installation of the gauge of temperature
   Removal, installation and check of a sound signal
   Remote control initialization by the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Illumination devices
   Replacement of lamps накаливания
   Removal and headlight installation
   Adjustment of headlights
   Removal and installation of a back lantern
   Monitors
   Removal and installation of the block of the panel of devices
   Replacement of lamps of the block of the panel of devices
   Removal and installation of the switch of signals of turn/screen wiper
   Removal and radio receiver installation
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled стеклоомывателя
   Removal and installation of a drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and pump replacement стеклоомывателя
   Work with electric schemes
+ Electric equipment schemes
+ System of onboard diagnostics


Check of lamps накаливания

 CHECK

1. Remove a lamp and check up it visually. If the lamp incandescent filament has fused or the glass flask unsteadily sits in a socle, a lamp replace.
2. For exact check of serviceability of a lamp it is necessary to do the following:
Attach a lamp directly to the storage battery. Polarity observance in this case is unessential. One wire attach to feeding contact of a lamp, another to the lamp case. If the lamp does not light up, it is necessary to replace it. It is necessary to check up also, whether there are no corrosion traces on the lamp case. In the presence of a rust smooth out its skin.
3. If the lamp is serviceable, insert it into a cartridge and include. If the lamp does not light up, check up a food by a control lamp. For this purpose attach a control lamp to weight. Joining is carried out as follows. One wire of a control lamp joins a weight point on the engine (the smoothed out metal) or is direct to a negative pole of the storage battery. Other end of a control lamp (+) joins or the current carrying tip or is stuck in a current carrying cable. If now the control lamp lights up, and the checked lamp does not burn, there is a breakage in a weight wire to a lamp. For check put a weight wire to a lamp cartridge. Now the lamp should light up.
4. If pressure in a current carrying cable to a lamp is not present also a control lamp does not light up, switch damage is probable. Check up the switch.
5. Otherwise check up the lamp module.