BMW 5 series E39

1. Adjust position of the persistent screw (1) left and right loops so that the size А=25 1 mm.
2. Check up an emphasis (2). If necessary replace a loop

1. Adjust cowl position by the adjusting device. Address to an accompanying illustration.

The cable should not be tense. On an illustration the cable and locks are shown on a portable element.

2. If it is necessary, adjust a course of a drive of a cowl the adjusting screw (an arrow on an accompanying illustration).

3. Completely screw an emphasis.

1. Ослабьте bolts of fastening (1) and (2) left and right loops so that could be shifted a cowl.

2. Close a cowl and expose it concerning the right and left wings.

If the range of adjustment does not suffice, ослабьте bolts of fastening of loops of a cowl to a body and displace them concerning a body.

3. Cautiously open a cowl and fix cowl bolts.

1. Adjust height of a cowl around loops. For this purpose close a cowl and measure a deviation on cowl height in relation to wings.
2. Open a cowl and bring under it a support or ask to take the assistant.

3. Turn out bolts (1) and (2) and depending on a deviation from correct position take out or insert linings.

4. Tighten fastening bolts at the left and on the right.
5. Again check up position on height. If necessary repeat adjustment.

1. Ослабьте bolts of fastening of pins of the lock so that they could move.

2. Some times close the lock so that locks were combined.

Do not close a cowl on the lock.

3. Tighten bolts of fastening of pins of locks.

4. Turn away a counternut (1) and turn a screw-driver a lock pin.

5. Thus adjust equal position of a cowl in relation to wings. Pay attention to achievement of a parallel backlash in relation to facing.
6. Tighten a counternut.
7. Check up, that locks were reliably fixed. If necessary repeat adjustment.

1. Open a cowl.
2. Turn out an emphasis so that the cowl was under some pressure. For this purpose make of plasticine two columns in height about 10 mm. Put them under an emphasis and close a cowl. Then open a cowl and measure height of an emphasis and the compressed columns. Turn out an emphasis on the received value of height of 0.5 mm. In the specified way adjust all emphasis.
3. Check up, whether the cowl without backlashes on all emphasis lies. If necessary repeat adjustment.

The cowl should not act under wings. Otherwise at car movement there is a wind noise

4. Measure выступание a cowl over рассеивателем headlights. It should make And = 4 1 mm. Otherwise adjust headlight position.

5. Ослабьте bolts (arrows on an accompanying illustration) also displace a headlight forward or back.

Do not put pressure upon a headlight. If necessary displace the bottom bolts of fastening.

6. If the headlight has been displaced, check up its adjustment.