BMW 5 series E39

Since 1996-2001 of release

Repair and car operation



BMW E39
+ Introduction
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   Care of a body
   Care of the panels of furnish made of vinyl
   Care of an upholstery and salon rugs
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   Kuzovnye backlashes
   Removal and installation of a forward bumper
   Removal and installation of shock-absorbers of a forward bumper
   Removal and installation of a back bumper
   Removal and installation of the shock-absorber of a back bumper
   Removal and installation of a forward wing
   Removal and cowl installation
   Adjustment of position of a cowl
   Removal and installation of a cover of a luggage carrier
   Adjustment of position of a cover of a luggage carrier
   Removal and installation of back facing of a luggage carrier
   Removal and installation of the lock of a cover of a luggage carrier/cylinder of the lock
   Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
   Overlay replacement / a firm inscription
   Removal, installation and door adjustment
   Removal and installation of facing of a door
   Removal and door-lock installation
   Removal and installation of the external handle of a door
   Removal and installation of the cylinder of the lock
   Removal and installation of the electric motor/microswitch of the uniform lock
   Removal, installation and adjustment of door glass
   Removal and installation electric стеклоподъемника
   Removal and installation of an external mirror
   Removal and installation of glass of a mirror
   Removal and installation of the case of an external mirror
   Removal and installation of an internal mirror
   Removal and installation of the central console
   Removal and electric motor installation сдвижной panels of the hatch of a roof
   Removal and installation of a forward seat
   The device of a tension of a seat belt
   Security measures at the reference with the device of a tension of a belt
   Protection of the device of a tension of a belt
   Removal and installation of a back seat
   Removal and shelf installation under a headdress
   Removal and installation of jalousie of back glass
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics


Removal and installation of facing of a door

Here removal of facing of a forward door is described. Process of removal of facing of a back door is approximately similar. Differences are described in the end of Section.

 REMOVAL

1. Disconnect a cable of weight from the storage battery. The battery is in a luggage carrier behind the right lateral facing.

At a battery detachment the data in electronic blocks of memory, for example, memories of malfunctions of the engine is erased. Address to recommendations Has undressed Removal and installation of the storage battery.

2. Isolate a negative pole of the storage battery for an exception of casual electric contacts.

3. Turn out a bolt (1) in the air channel.

4. Take out a screw-driver a plafond of the bottom illumination of salon, расстыкуйте штекерное connection and remove a lamp.
5. Take out a small screw-driver the switch (2) storing of position of a seat. Расстыкуйте штекерное connection also remove the switch.

6. Take out a small screw-driver the console of management (3) стеклоподъемника and exterior mirrors.

7. Remove the tip as follows:
   - The tip 1: Wring out sideways a small screw-driver a stopper, without taking out it. The switch is taken out upward by the lever mechanism.
   - The tip 2: Press downwards a lock hook and incline aside a lock clip. The switch is taken out upward.

8. Remove the management console.

 

9. Take out a peak (4) of an aperture of the door handle and turn out a bolt being under it.

10. Disconnect door facing sideways and from below. For this purpose delay fingers of edge of facing. The arrangement of clips (arrow) is shown on an illustration.

11. Displace facing upward and release it from the central clip and from top скоб. The clip is on a facing inside in area ().
12. Shift a door drive through an aperture in facing.
13. Raise and remove facing under the button of blocking of a door (2).

14. If the central clip (1) remained on a door, remove it, as is shown in an accompanying illustration and fix on facing.

15. Disconnect a loudspeaker cable. Turn away screws of fastening and remove a box of a loudspeaker (1).

Observe security measures at work with a safety pillow, address to Security measure Section at work with a safety pillow.

16. Расстыкуйте штекерное connection (orange colour) lateral pillow of safety. Turn away screws of fastening and put a pillow of safety with a cover upward, for example in a luggage pocket.

17. Disconnect a cable (1) from the internal handle of a door and remove it.

18. If it is necessary, cautiously remove пенопластовую facing from an internal part of a door.

That glutinous consolidation remains on polyfoam, it is recommended to remove it jerky at low temperature.


 INSTALLATION

1. Carefully paste пенопластовую facing to a door.

Avoid facing damages as it can lead to draught occurrence in salon. The glutinous weight should be put on all contour of facing.

2. Connect a cable to the internal handle of a door.
3. Fix on a door a lateral pillow of safety. Join штекерное connection.
4. Fix a box of a loudspeaker and connect the tip.

5. Check up, whether there are all clips of internal facing of a door. The damaged clips replace.

6. Establish facing. The internal handle of a door and electric wires pass through apertures. Lay sound insulation (1) round a cable стеклоподъемника and paste in a facing aperture. Watch that the door drive was in a plastic support.

7. Insert facing from above over the fixing button. Put it at height of a lath of mine of a door, delay from below a little and fix finger-tips at an angle downwards to a door in five top скобах.

Additions to removal and installation of facing of a back door

Remove the door handle (address to an accompanying illustration)
   a) Remove a screw-driver a peak.
   b) Turn out the screw being under it.
   c) Remove from an axis the handle of lifting of glass and remove glass.