BMW 5 series E39

1. Establish a seat vertically and shift it completely forward.

2. Turn out the screw of fastening of a seat belt.

3. Take away back a stopper (1) and take out it inside. A drive of adjustment of height of a belt (2) take out forward.

4. Turn out internal peaks upward (1). For this purpose unclench a clip. Take out it in the middle of (2) upward and remove back (3).

5. Расстыкуйте штекерное connection (2), having opened a stopper (1).

6. Turn out back bolts.

7. Displace a seat completely back.

8. The electric drive of adjustment of a seat: Open a cover () forward. Open (1) stopper () and расстыкуйте штекерное connection (2).

9. Turn out forward bolts.

If the seat is transported, acts in film or long time remains removed, block натяжитель a seat belt, address to Section Protection of the device of a tension of a belt.

1. Establish a seat.

The rug should be in area of points of fastening of screws, instead of between directing seats and днищевым sheet. Otherwise at car movement there can be an extraneous noise.

2. Fix a seat new bolts. At first behind, then in front. Do not tighten fastening bolts.

3. Fix bolts the moment of 40 Nanometers in sequence: the forward internal, forward external, back internal, back external.
4. The electric drive of adjustment of a seat: Put a seat completely back, join штекерное connection and fix it. Establish a cover.
5. Connect multiitem штекерное connection and fix it.
6. Fix peaks.
7. Connect a cable of a drive of adjustment on height and fix it.
8. Fix a seat belt below the moment of 50 Nanometers.

1. Remove a peak internal directing seats.
2. Establish the mechanism of adjustment of an inclination of a seat in the top position.
3. Disconnect the tip from the pump if it is available.
4. Turn away two bolts of fastening of a lobby directing seats and overturn a seat back.
5. Turn out two bolts of fastening of the electric drive of adjustment of longitudinal position of a seat and remove a drive.
6. Press the switch of adjustment of longitudinal position.
7. Adjustment does not work: Attach a new drive and include it. If now adjustment works, the reducer is serviceable. It is necessary to replace only the electric drive.
8. The electric drive works, the seat does not move: the reducer Is faulty. Replace it.
9. Расстыкуйте штекерное connection of longitudinal adjustment of a seat.
10. Cut a connecting shaft.
11. Turn on two nuts of fastening and remove a reducer at the left and on the right. After that the seat can be displaced a hand.
12. Fix bolts directing seats (only for removal).
13. Remove a seat and replace directing on the new.