| 1. Periodically check liquid level in system of hydrostrengthening of a wheel in order to avoid occurrence of problems with management of the car, such, as damage of the steering pump. Operate as follows.
|
| Do not keep a steering wheel turned against the stop in this or that party more than five seconds. It can put out of action the steering pump. |
|
2. The tank of system of hydrostrengthening of a wheel is located in the left part of an impellent compartment and has unscrewing cover with built in in it measuring щупом. |
|
3. Park the car on an equal platform and cock a lay brake.
4. Oil level can be checked at cold or heated-up oil. Heated-up oil has temperature nearby + 80С, cold oil has an ambient temperature.
5. Turn away a stopper of the tank of oil on the cooled engine. The level index on a stopper wipe a pure rag. |
6. Put a cover on a mouth, without screwing up it, and remove again. Oil level should be between labels on the index. If necessary add oil. Added oil should be authorised firm BMW. Add necessarily new oil, since. Even insignificant pollution can cause hydraulic booster failures. |
|
7. Start the engine and if necessary add oil that it was between marks in the index.
8. At the working engine turn some times a steering wheel from an emphasis against the stop. Thus from system air leaves.
9. Stop the engine.
|
| The liquid modulation is supposed no more than 5 mm above the MOVE. Remove surpluses pure шприцом. Close a cover. |
Check up sealing rings on a stopper. If necessary replace.
10. Close the tank a stopper.
11. If it is required frequent доливание to a liquid, check up hoses and штуцерные connections of system of hydrostrengthening of a wheel on presence of signs of deterioration and leaks.
12. Check up a condition приводного a belt (address to Section condition Check приводных belts). |