BMW 5 series E39

Since 1996-2001 of release

Repair and car operation


BMW E39
+ Introduction
+ The maintenance instruction
- Current leaving and service
   The routine maintenance schedule
   Introduction
   Current leaving
   The general information on adjustment
   Check of levels of liquids
   Check of a condition of tyres and pressure in them
   Replacement of impellent oil and the oil filter
   Check and adjustment of turns of idling of the engine and level WITH
   Replacement of an element of the air filter
   Replacement of the filter of air of salon
   Check of brake system
   The visual control of the bottom and body elements
   Check of level of a liquid of system of hydrostrengthening of a wheel
   Wheels and tyres. Rotation, replacement, balancing and leaving. Snow chains. “Секретки” wheels. Elimination of trembling of a wheel
   Check of a condition and replacement of hoses of an impellent compartment
   Condition check приводных belts
   Check of a condition of the battery, care it and gymnastics. Replacement of an element of a food брелка ДУ
   Check and replacement of spark plugs
   Check of functioning of fuel system. Winter operation of the Diesel engine
   Check of functioning of system of cooling
   Check of a condition of system of release of the fulfilled gases
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts
   Greasing запорных devices
   Visual check of seat belts
   Check of a condition and replacement of brushes of screen wipers
   Replacement of a brake liquid
   Replacement of a liquid of system of cooling. Check of frost resistance of a cooler. Visual check of system of cooling
   Sediment removal, replacement of the fuel filter. Removal of air from fuel system of the diesel engine
   Replacement трансмиссионного oils of a manual box of a gear change
   Replacement of a lubricant liquid of differential
   Check of a thickness of a conducted disk of coupling
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
+ System of onboard diagnostics

Check and adjustment of turns of idling of the engine and level WITH

TIME IN 2 YEARS OR EACH 20 000 KM OF RUN

The engine should be heated-up to normal working temperature, with correctly established corner of an advancing of ignition and the adjusted backlashes of valves (there where they are regulated). The air filter should be in a good condition, and all electric components (including air central air where it is available) should be switched off.

The petrol engine

 PERFORMANCE ORDER

1. Connect a tachometre and a measuring instrument WITH to the engine. Mechanics use a special With-tester, which probe is established in the pipeline of system of release, but it is possible to use a usual tester which is inserted into an exhaust pipe. However pay attention that on models with каталитическим the converter on an exhaust pipe it is impossible to receive correct indications of the maintenance WITH.
2. To adjust manually idling turns it is impossible, as the stabilising valve of idling is put in action by the electronic block of management. If at normal working temperature of the engine idling turns do not correspond to the values specified in Specifications, check up system of a fence of air on presence of leaks, and also work of the valve of idling.
3. Verify indications of a measuring instrument WITH with the values resulted in Specifications. If adjustment is required, take заглушку from a measuring instrument of an air stream and turn the adjusting screw before reception of demanded value (on some models it can be demanded шестигранный a key). In summary establish new protective заглушку.

The diesel engine

Most the challenge at idling adjustment is represented by tachometre joining as available and tachometres are intended sale for connection to the coil of ignition of the petrol engine. To reach necessary adjustment of idling it is possible under condition of correct adjustment of valves and the moment of injection of fuel.

Check of idling of the Diesel engine is made as follows:

 PERFORMANCE ORDER

1. Start and warm up the engine to working temperature. Disconnect from the engine all electric consumers. If automatic transmission is established, switch a transmission in neutral position.
2. Start the engine and check up number of its turns on a tachometre or estimate it on hearing. Non-uniform work of the engine is felt at once.
3. If the number of turns of the engine falls outside the limits Specifications, a screw-driver turn the adjusting screw so that the engine worked in regular intervals on single turns. For increase of number of turns the screw is rolled. The control lever gas thus moves outside.
4. Keeping the adjusting screw a screw-driver, tighten a counternut.