|
Check of a condition and replacement of brushes of screen wipers
On brushes of screen wipers the road film in due course collects, reducing efficiency of their work, therefore brushes should be washed out regularly in a soft cleaning solution.
Check
Assemblages of screen wipers with brushes should look round regularly. If survey has revealed presence of hardenings or cracks on rubber of brushes, replace brushes. If at survey it is not revealed anything unusual, wet a windscreen, include screen wipers, allow to them to work a little and switch off them. A non-uniform trace from brushes on glass or strips on pure glass specify that it is necessary to replace brushes.
During work of the mechanism of screen wipers there can be an easing of fixing nuts, therefore they should be checked and necessarily to tighten each time at check of brushes.
Replacement of brushes of screen wipers
|
1. Delay assemblage of a screen wiper with a brush from glass. |
|
2. Shift a toddler and remove assemblage of a brush from the screen wiper lever. |
|
3. If you wish to replace only rubber of brushes, disconnect the end of a brush from a brush framework, then pull out a brush from a framework. |
|
4. Compare a new brush with old on length, a design etc.
5. Establish a new brush into place, then insert its end into a brush framework to fix it.
6. Establish brush assemblage on the lever, then moisten glass and check up screen wiper work. |
|
|
|